3.4
Fusebox
The fusebox is an electronic box that controls the power supply to practically all
devices. Internally, the thermal fuses reset automatically, so changing a fuse will
never be necessary. In case of malfunction it has to be sent to SEAT Sport.
It is also possible to check if a fuse has blown in the fusebox, so you will know if
the current or signal was sent.
There are three ways to check the correct functioning:
Live measures view in RaceStudio3.
Checking the fusebox control channels in Race Studio Analysis.
Checking the red LEDs on the fusebox.
If a malfunction is detected, it is necessary to control the corresponding wiring or
the device.
In the following table is shown the fuse analysis information:
Channel name: There are 5 channels to analyse.
Bit number: Each channel is able to control 8 fuses.
Data value: Is the value you can check on data acquisition.
Channel name
Bit number
bit8
bit7
bit6
bit5
FLAG_FBX_F5
bit4
bit3
bit2
bit1
bit8
bit7
FLAG_FBX_F4
bit6
bit5
bit4
Data value
-------8
Sadev pump
------7-
HR-ECU
-----6--
HR-Fuel pump
----5---
Starter
---4----
Radio
--3-----
HR-Lambda
-2------
HR-Miscellaneous
1-------
HR-Injectors
-------8
MR-ignition coils
------7-
Sadev-ELV
-----6--
Drink
----5---
Switch Panel / Aux. Data connector
---4----
Steering Wheel
Fuse box LED label
Description
19