Dell S2815dn Installation And Configuration Manual page 7

k. If you wish to enter the gateway, press the F key
l.
m. To confirm this operation was successful, you can
Automatic (DHCP) LAN IP Address Configuration:
4. Using the card reader keypad, enable DHCP using the
following steps. See Figure 1 below.
a. Press the F key; the display will say
b. Press the F key again; the display will say
c. Press the Enter key; the display will show
d. Press the Enter key; the display will show
e. Press the F key to change the setting from OFF to
f.
g. After reboot and initialization, press the F key; the
h. Press the F key again; the display will say
i.
j.
CACStar User Guide Rev A27
Copyright 2017 Digital Imaging Technology
again and enter it as you did the IP Address.
Press the Exit key twice to return to
Card
.
ping the CACStar at its new IP address from your PC.
Configuration
.
and the current setting. The default is OFF.
Change X = Exit
.
ON.
Press the Enter key. After about 3 seconds,
CACStar will reboot.
Information
display will say
Configuration
.
Press the Enter key; the display will show
and the current setting.
Press the F key again; the display will show
Address
and the current setting.
Waiting for
Information
.
.
DHCP
F =
DHCP
LAN IP
Page 7