Initial Setup - Dell S2815dn Installation And Configuration Manual

Initial Setup

1. The printer must be configured to use DHCP which is the
default configuration.
2. Turn the power on. After initialization is complete, the Card
Reader display will say
1 ½ minutes.
Manual LAN IP Address Configuration:
3. Using the card reader keypad, enter the IP address to be
used to access both the CACStar and the MFD/printer. See
Figure 1 below.
a. Press the F key; the display will say
b. Press the F key again; the display will say
c. Press the Enter key; the display will show
d. Press the F key again; the display will show
e. Press the Enter key; the display will show
f.
g. The display will say
h. Press the F key; the display will say
i.
j.
CACStar User Guide Rev A27
Copyright 2017 Digital Imaging Technology
Waiting For Card
Configuration
.
the current setting. The default is OFF.
Address
and the current setting.
Value.
Enter the desired IP Address and press Enter. Use
the IP address you want to use for the host
connection to the MFD/printer.
i. Example: 192.168.1.23 Enter.
and the current setting.
Press the Enter key; the display will show
Value.
Enter the desired subnet mask like you did the IP
Address.
. This will take about
Setting Value
for about 5 seconds.
Information
.
DHCP
and
LAN IP
Enter New
LAN Subnet Mask
Enter New
Page 6