Advertisement
Figure 32
Figure 33
Figure 34
20
the roof, run a bead of non-hardening sealant
around the outside top edges of the Support
Box so as to make a seal between the box and
the roof. Clean out any combustible material or
debris from inside the Support Box.
8. Place the Support Clamp, included with
Support Box, loosely around Pipe Sections
running through hole in Support Box (Figure
33).
9. Connect the necessary amount of Pipe
Sections to reach the stove and extend at least
12-inches above the roof before attaching
Termination Cap (Figure 32).
10. After all Secure Pellet Pipe Sections and
components are assembled and connected
down to the appliance seal and secure the
Appliance Adapter to stove. Using a level,
make slight adjustments in the position of the
appliance until the pipe is truly vertical. Tighten
the bolts in the Support Clamp (Figure 33).
Note that the overall length of the Vent system
can be no longer than 42 feet.
11. Slip Roof Flashing over the supported
Pipe Section(s) protruding through the roof.
Apply sealant to underside of Roof Flashing
along upper edge and sides. Secure the base
of Roof Flashing to the roof with roofing nails
(Figure 34). Ensure that the roofing material
overlaps the top edge of the Roof Flashing.
CLEANING AND MAINTENANCE
1. Have your system cleaned by a certified
chimney sweep if you have doubts about your
ability to clean it. Use a plastic or flexible steel
brush. Do not use a stiff brush that will scratch
the stainless steel liner of your system.
2. Vent systems must be installed so that
access is provided for inspection and cleaning.
3. The system should be inspected at least
once every month during the heating season.
4. Do not use chemical cleaners. They can
damage the vent pipe.
Advertisement
