3. Unit Nomenclature and Function
Nomenclature of Unit Components
Component names of the product are shown in Figure 3.1 below.
①
②
3G ANT
12-24VDC
⑩
⑪
LAN A
LAN B
⑬
Figure 3.1. CPS-MG341G-ADSC1-930
1. Power Connector: Use the 3-pin connector, included in this package.
2. Antenna Connector: Use the supplied connector or optional one listed in the chapter 5.
3. SIM Slot: It is a slot for inserting SIM card.
4. 3G LED: Display the intensity of the signal reception.
5. Debug Connector: Please do not use it.
6. SD Card Slot: It is for data storage.
7. USB: It is a USB port.
8. RS-232C: It is a RS-232C serial ports (male).
9. LED: It indicates status of this product.
10. Reset Switch: This resets the product.
11. Shut down Switch: This shuts down the product.
12. DIP Switch: It is used for system setup and RS-422A/485 setup.
13. LAN: It is a connector for LAN.
14. Digital I/O, Counter Input: Use the 10-pin Connector, included in this package.
15. Analog Input: Use the 3-pin Connector, included in this package.
16. RS-422A/485: Use the 5-pin Connector, included in this package.
CPS-MG341G-ADSC1-930 Hardware Manual
⑥
⑦
⑧
③ ④ ⑤
3G LED
USB
RS-232C
COM B
SD
Half
F ull
Isolated R S -422A/485
DI/CNT
DO0 DO1
AI0
AI1
+
+
+
+
⑭
⑮
⑨
Half
F ull
COM A
⑯
3 Unit Nomenclature and Function
33