Table of Contents
Advertisement
1 Before Using the Product
- Do not use or store this product in a location exposed to high or low temperature that exceeds range of
specification or susceptible to rapid temperature changes.
e.g.
- Exposure to direct sun
- In the vicinity of a heat source
- Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product must
be used in such an environment, install it on a dust-proof control panel, for example.
- Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
- Avoid transporting this products state to shock or vibration that exceeds range of specification.
Impact resistance: 15G (11ms) below
- Use the product in the specified operating condition (temperature, humidity, vibration and shock)
- Please be grounded (earth) always.
- Avoid installing in the place where ventilation of the product may compromise. Insufficient aeration
could heat up the product and lead to malfunctions or damages.
- Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
- Do not use or store this product in the presence of chemicals.
- When removing connectors or cables, never fail to unplug the power cables and confirm the LEDs are
turned off.
- CONTEC reserves the right to refuse to service a product modified by the user.
- In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact your retailer.
- To connect with peripherals, use a grounded, shielded cable.
- To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
- When connecting cables, first check the shapes of connectors (such as USB connectors), and then
insert them in the correct orientation. After they are connected, do not put too much load on the
connected part. Doing so may result in poor contact or damage to this product and the connected part.
- Do not touch metal parts or terminals of the product with your hands in operation. Otherwise,
this product may malfunction, overheat, or cause a failure.
- To avoid electric shock, please do not touch the system with a wet hand.
- The specification of this product is subject to change without notice for enhancement and quality
improvement. Even when using this product continuously, be sure to read the manual of CONTEC's
website and understand the contents.
- If you want to use in places where the influence of the overcurrent or overvoltage is, please select
appropriate surge protection device for all of the route (Power line, LAN, RS-422A/485, AI, DIO,
earth, etc.)
- Regardless of the foregoing statements, CONTEC is not liable for any damages whatsoever
(Including damages for loss of business profits) arising out of the use or inability to use this CONTEC
product or the information contained herein.
- When disposing this product, please comply with the municipal regulations and ordinances.
- Regarding the power supply of this product and digital I/O.
For UL-certified, connecting to both SELV and Limited Energy Circuit is required.
Additionally, Class 2 power supply can also be used in the U.S.
6
CPS-MG341G-ADSC1-930 Hardware Manual
Advertisement
Table of Contents
