Set Up A Dynamic Dns Service Account - TP-Link Archer VR300 User Manual

Ac1200 wireless vdsl/adsl modem router
Table of Contents

Advertisement

Chapter 13
Short GI:
This feature is enabled by default and recommended to increase the data
capacity by reducing the Guard Interval (GI) time.
AP Isolation:
Select this check box to enable the AP Isolation feature that allows you
to confine and restrict all wireless devices on your network from interacting with each
other, but still able to access the internet. AP isolation is disabled by default.
WDS Bridging:
Select this check box to enable the WDS (Wireless Distribution
System) Bridging feature to allow the router to bridge with another access point (AP)
in a wireless local area network (WLAN).
WPS:
Select this check box to enable the WPS feature. WPS (Wi-Fi Protected Setup)
provides you with an easier approach to set up a security-protected Wi-Fi connection.
13 4

Set Up a Dynamic DNS Service Account

Most ISPs (Internet service providers) assign a dynamic IP address to the router and
you can use this IP address to access your router remotely. However, the IP address
can change any time and you don't know when it changes. In this case, you might need
the DDNS (Dynamic Domain Name Server) feature on the router to allow you and your
friends to access your router and local servers (FTP, HTTP, etc.) using domain name, in
no need of checking and remembering the IP address.
Note: DDNS does not work if the ISP assigns a private WAN IP address (such as 192.168.1.x) to the modem router.
To set up DDNS, please follow the instructions below:
1
Visit http://tplinkmodem.net, and log in with your TP-Link ID or the password you
set for the router.
2
Go to
Advanced
3
Select the
DDNS service provider
4
To use TP-Link DDNS service, you should log in with your TP-Link ID.
5
If you choose other DDNS service, you should also log in with your DDNS account,
select a service provider and click
and domain name of the account (such as lisa.ddns.net).
>
Network
>
Dynamic DNS.
(TP-Link, Dyndns or NO-IP).
Go to register ...
Specify Your Network Settings
Enter the username, password
66

Advertisement

Table of Contents
loading

Table of Contents