Ideal Air 700807 User Manual page 6

SETTING ANGLE OF AIR FLOW
SETTING VERTICAL ANGLE OF AIR FLOW
While the unit is on, use the SWING/DIRECT button to set the direction (vertical angle) of airflow.
• Press the SWING/DIRECT button once to activate the louver. Each time you press the button, it will adjust the
louver by 6°. Press the button until the direction you prefer is reached.
• To make the louver swing up and down continuously, press and hold the SWING/DIRECT button for 3 seconds.
Press it again to stop the automatic function.
SETTING HORIZONTAL ANGLE OF AIR FLOW
The horizontal angle of the airflow must be set manually. Grip the deflector rod (See FIG. B) and manually adjust it to
your preferred direction. FOR SOME UNITS, the horizontal angle of the airflow can be set by remote control. Please
refer to the Remote Control Manual.
When using COOL or DRY mode, DO NOT set louver at too vertical an angle for long periods of time.
This can cause water to condense on the louver blade, which will drop on your floor or furnishings.
(See FIG. A) When using COOL or HEAT mode, setting the louver at too vertical an angle can reduce
the performance of the unit due to restricted air flow. DO NOT move louver by hand. This will cause
the louver to become out of sync. If this occurs, turn off the unit and unplug it for a few seconds, then
restart the unit. This will reset the louver.
CAUTION
DO NOT put your fingers in or near the blower and suction side of the unit. The high-speed fan inside the
unit may cause injury.
Range
Caution: do not keep louver at too vertical of an
angle for long periods of time. This can cuase water
condensation to drip on your furnishings.
SLEEP OPERATION
The SLEEP function is used to decrease energy use while you sleep (and don't need the same temperature settings to
stay comfortable). This function can only be activated via remote control. Press the SLEEP button when you are ready
to go to sleep. When in COOL mode, the unit will increase the temperature by 1°C/2°F after 1 hour, and will increase
an additional 1°C/2°F after another hour. When in HEAT mode, the unit will decrease the temperature by 1°C/2°F
after 1 hour, and will decrease an additional 1°C/2°F after another hour. It will hold the new temperature for 5 hours,
then the unit will turn off automatically.
Set
temperature
Z
Z
Z
NOTE: ON LOUVER ANGLES
FIG. A
SLEEP Operation
1hr
+/- 1 C/2 F
+/- 1 C/2 F
Saving energy during sleep
Deflector rod
FIG. B
1hr
6
7 hours
timer o
The SLEEP
function is not
available in FAN
or DRY mode.
NOTE: