Advertisement
Operating Your Tower Fan
To operate the tower fan, plug the
power cord into a 230V or 240V
electrical outlet and switch on.
Be sure that the plug fits tightly as a
loose fit will cause overheating
and damage the plug.
NOTE: To avoid an electrical circuit
overload, it is recommended that
no other appliances are plugged
into the same circuit as your fan,
when it is in use.
NOTE: To avoid infrared interference
that may trigger the operation
of the cooling fan, ensure the
fan is positioned away from
other infrared remote controlled
appliances.
Fan Speed Settings
The tower fan has three fan speed
settings; (LOW), (MED) and (HIGH).
To start the tower fan, turn the
tower fan on by pressing the 'FAN'
button once; the unit will be in
NORMAL fan mode, at LOW speed
setting.
Pressing the 'FAN' button a second
time will set the tower fan into
MEDIUM speed setting. Pressing the
'FAN' button a third time will set the
tower fan into HIGH speed setting.
To turn the tower fan OFF, press the
'FAN' button continuously until none
of the indicator lights are illuminated
on the control panel display and the
fan is no longer running. Then turn off
at the power outlet and remove the
plug from the power outlet.
Setting the Nature and
Reduction Mode
The tower fan has a NATURE and
REDUCTION setting.
Both the NATURE and REDUCTION
modes can be used on any fan
speed. The LED screen will indicate
what mode the fan has been set in.
Nature Mode
The NATURE mode simulates the
natural rise and fall of the wind over
time.
Once a fan speed setting is selected,
press the 'MODE' button once to
activate the NATURE setting. The fan
will now alternate between the
pre-selected setting, all lower settings
and OFF.
To switch the NATURE mode off, press
the 'MODE' button twice, until the
indicator light disappears.
Reduction mode
The REDUCTION mode allows you to
decrease the fan speed over time.
Once a fan speed setting is selected,
press the 'MODE' button twice to
activate the REDUCTION setting. After
30 minutes, the selected setting will
drop to the next lowest setting.
For example if the fan speed is set at
MED, after 30 mins it will drop down
to LOW, and remain on LOW until the
unit is turned off.
To switch the REDUCTION mode off,
press the MODE button once. The fan
will now be in normal operation
Setting the Oscillation
This function will work in any mode.
Pressing the 'OSC' button once
will allow the tower fan to oscillate
from side to side. To stop the unit
oscillating, press the 'OSC' button
once more.
9
Advertisement
