Welcome! Table of contents Thank you for purchasing the Cassette Car Getting Started Stereo. Resetting the unit ..........3 Setting the clock ..........3 Cassette Player Listening to a tape ..........4 Playing a tape in various modes ....... 4 Radio Memorizing stations automatically —...
Setting the clock Getting Started The clock has a 12-hour digital indication. For example, setting it to 10:08 Press (DSPL) for two seconds. Resetting the unit Before operating the unit for the first time or The hour digit flashes. after replacing the car battery, you must reset the unit.
Locating the beginning of a track — Automatic Music Sensor (AMS) Cassette Player You can skip up to nine tracks at one time. During playback, press either side of (SEEK/AMS) momentarily. Listening to a tape To locate the succeeding tracks SEEK Insert a cassette.
Switching to the radio while fast- winding a tape Radio — Automatic Tuner Activation (ATA) Press (5) during playback. “ATA” appears on the display. Memorizing stations When fast-forwarding or rewinding with (SEEK/AMS), the tuner will turn on automatically automatically. — Best Tuning Memory (BTM) To cancel this mode, press (5).
Memorizing only the Receiving the memorized desired stations stations Up to 6 stations on each band (FM1, FM2, FM3, Press (SOURCE) repeatedly to select the MW, SW1 and SW2) can be stored on the tuner. preset number buttons in the order of your choice.
Changing the sound and Other Functions beep tone Boosting the bass sound — D-Bass You can enjoy clear and powerful bass sound. Adjusting the sound The D-bass function boosts the low frequency signal with a sharper curve than conventional characteristics bass boost.
Additional Notes on Cassettes Cassette care Information • Do not touch the tape surface of a cassette, as any dirt or dust will contaminate the heads. • Keep cassettes away from equipment with built-in magnets such as speakers and amplifiers, as erasure or distortion on the Precautions recorded tape could occur.
Location of controls INTRO REPEAT MODE SOURCE BL.SKIP SEEK OFF 1 2 DSPL D-BASS MUTE Refer to the pages for further details. 8 Reset button 3 1 SEEK/AMS button 4, 5, 6 Press this button when you use this unit 2 SOURCE button (TAPE/TUNER) 4, 5, 6 for the first time, when you have changed 3 (+)(–) (volume/bass/treble/balance/...
Specifications Cassette player section General Tape track 4-track 2-channel stereo Outputs Power antenna control Wow and flutter 0.08 % (WRMS) lead Frequency response 30 – 20,000 Hz Power amplifier control lead Signal-to-noise ratio 58 dB Tone controls Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz Tuner section Power requirements...
Troubleshooting guide The following checklist will assist in the correction of most problems you may encounter with your unit. Before going through the checklist below, refer to the operating procedures. General Problem Cause/Solution • Adjust the volume with (+). No sound. •...
Need help?
Do you have a question about the XR-T200 and is the answer not in the manual?
Questions and answers