Advertisement
9) After the factory infotainment system has booted, quickly
press the Home button 2 times to enter the interface menu.
10) If the screen enters the RearSight
®
interface menu, all
connections to the vehicle are complete. Next you will connect
your cameras to the RearSight
®
interface module. Install your
cameras per the instructions provided with them. Run power
for each camera from an ACC +12V source. Route your
camera RCA cables to the Interface module location.
11) Once all connections are made, the module can be
mounted or located anywhere behind or near the control
panel. It us up to the installer to determine the best mounting
location and route their wiring accordingly.
Camera Connections
Note:
All Cameras MUST be wired to ACC +12V in order to
use the monitoring functions. The red wire on the Rear Camera
input lead will provide power when the aftermarket rear camera
is activated and selected. DO NOT connect the camera power
leads to the turn signals or reverse lamps. The RearSight
®
interface uses CAN technology to select the correct camera to
display.
www.rostra.com
(800) 782-3379
Advertisement
