Spark Igniter And Electrodes; Burner Grates - GE ZGP304 Owner's Manual

Spark Igniter and Electrodes

The electrode of the electronic ignition system is
positioned at the rear of the burner base. When cleaning
the cooktop, be careful not to snag the igniter with your
cleaning cloth. Damage to the igniter could occur.
Be careful not to push in a control knob while cleaning. It
could cause the igniter to spark.
Make sure that the white ceramic igniters on the cooktop
are dry and clean. Clean the metal portion of the
electrode with a soft cloth or emery board.
Do not attempt to remove the electrode from the
cooktop.

Burner Grates

The enameled cast-iron burner grates should be cleaned
regularly.
You must put the grates on the self-clean oven rack
during the self-clean cycle. DO NOT put the grate on
the oven floor during a self-clean cycle. DO NOT put the
frame inside the oven during a self-clean cycle. Only the
grate can withstand the heat of the self-clean cycle. The
frames may be cleaned by hand or in the dishwasher.
Wash them in hot soapy water, rinse, and dry thoroughly.
Although they are durable, the grates will gradually lose
their shine, regardless of the best care you can give
them. This is due to their continual exposure to high
temperatures.
Do not operate a burner for an extended period of time
without cookware on the grate. The finish on the grate
may chip without cookware to absorb the heat.
32
Clean this metal part
with an emery board.
Do not clean this white
ceramic part with an
emery board.
For stability, the frames have rubber pads on each
corner. During cleaning and use, be careful not to
damage or snag rubber pads.
Grates
Frame
Pads
49-85244