Dyeing/Bleaching; Soaking; Programme Default Settings; Temperature - Bosch WAT28780SA Instruction Manual And Installation Instructions

Dyeing/bleaching

Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do not use the washing machine to
bleach clothes.

Soaking

Switch on the appliance.
1.
Select the Cottons 20 °C program.
2.
Pour soaking agent/detergent into
3.
compartment II in accordance with
the manufacturer's instructions.
Press the A button.
4.
After approx. 10 minutes, press the
5.
A button to pause the program.
Leave the laundry to soak for as long
6.
as required, then either press the A
button again to continue the
program or change the program.
Notes
Load laundry of the same colour.
■
No additional detergent is required;
■
the soaking solution is used for
washing.
0
Programme default
settings
The programme default settings are
P r o g r a m m e d e f a u l t s e t t i n g s
displayed and can be changed in the
touch display after the programme is
selected.
You can find an overview of all possible
program settings on the supplementary
sheet for the installation and operating
instructions.

Temperature

Programme default settings

Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.

Spin speed

Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting 2: No spin; the water is only
drained. The laundry stays wet inside
the drum, e.g. for items that should not
be spun.
The maximum speed that can be set
depends on the model and the
programme that has been selected.

Ready in time

After selecting a programme, the
programme duration is displayed, e.g.
1:51 (in h:min (hours:minutes)).
Before the programme starts, you can
move the time at which the programme
should be finished backwards, in
increments of 30 minutes and up to a
maximum of 24 h (h=hour).
After the programme starts, the
selected time, e.g. 8.5 h is displayed
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
The programme duration is
Note:
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
en
29