Introduction; Specifications; Unpacking - Powermatic DS20 Operating Instructions And Parts Manual

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and
maintenance procedures for a Powermatic Model DS20 Disc Sander. This manual contains instructions
on installation, safety precautions, general operating procedures, maintenance instructions and parts
breakdown. This machine has been designed and constructed to provide years of trouble free operation if
used in accordance with instructions set forth in this manual. If there are any questions or comments,
please contact either your local supplier or Walter Meier. Walter Meier can also be reached at our web
site: www.waltermeier.com.

Specifications

Model Number ............................................................................................................................. DS20
Stock Number (3HP, 3Ph, 230/460V – prewired 230V) ...............................................................1791264
Stock Number (2HP, 1Ph, 230V) ..............................................................................................1791276
Disc Diameter (in.) ............................................................................................................................ 20
Table Tilt (deg.) ............................................................................................................. 30 up, 45 down
Table Size (in.) .............................................................................................................. 27-1/2 x 10-1/2
Table Surface from Floor, minimum height (in.) ........................................................................... 28-3/16
Table Surface from Floor, maximum height (in.) ............................................................................ 35-7/8
Distance Between Disc and Table (in.) ............................................................................................ 0.20
Distance Between Mounted Abrasive and Table (in.)........................................................................ 0.17
Dust Port Diameter (in.)....................................................................................................................... 4
Dust Collection Minimum CFM Required .......................................................................................... 600
Disc Speed (RPM) ....................................................................................................................... 1,720
Overall Size (LxWxH)(in.) .............................................................................................. 31 x 28 x 48-1/2
Footprint (LxW)(in.) ........................................................................................................ 22-1/2 x 22-1/2
Net Weight, approximate (lbs.)......................................................................................................... 426
Shipping Weight, approximate (lbs.) ................................................................................................. 529
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier reserves the right to change specifications at any time and without
prior notice, without incurring obligations.

Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Disc
Sander is installed and running properly. Read
the instruction manual thoroughly for assembly,
maintenance and safety instructions.
Contents of shipping container:
1 DS20 Disc Sander
1 20" Abrasive Paper
1 Brake Assembly
1 Instruction and Parts Manual
1 Warranty Card
6