Rack-Mounting The Cisco Asr 1002 Router - Cisco ASR 1002 Hardware Installation Manual

Rack-Mounting the Cisco ASR 1002 Router

Note Make certain that the cable-management 'U' feature device has the open end pointing upwards when you attach
it to the chassis
Figure 10: Attaching the Cable-Management Brackets to the Cisco ASR 1002 Router
1
2
Step 6
Screw the cable-management bracket to each side of the rack-mount brackets already attached to the chassis. Use two
screws for each cable-management bracket. Use the package of four screws.
Step 7 Check that all screws are securely tightened.
Step 8 Go to Attaching a Chassis Ground Connection, on page
Rack-Mounting the Cisco ASR 1002 Router
The Cisco ASR 1002 Router can be installed in an existing rack with equipment or in an empty rack with no
equipment: The chassis can be mounted in either rack types:
• Two-post rack, either 19 inch or 23 inch. Inner clearance (the width between the inner sides of the two
If you are using a two-post rack secure the rack to the floor surface to prevent tipping and avoid bodily.
Note
Cisco ASR 1000 Series Router Hardware Installation Guide
20
Cable-management bracket
top and bottom screw
Cable-management bracket
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8 cm).
Airflow through the chassis is from front to back.
Cisco ASR 1002 Router Overview and Installation
3
—
31the to continue the installation.
Chassis front rack-mount
bracket
—