Download Print this page

Troubleshooting - Electrolux EWT 0862EWW User Manual

Hide thumbs

Advertisement

18
www.electrolux.com
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
With some problems, the acoustic
signals operate. The red indicator
flashes and one of the indicators comes
on, to show an alarm code:
- The appliance does not fill with
water properly.
13.2 Possible failures
Problem
The programme does
not start.
• The indicator of button Start/Pause
Possible solution
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance lid and drum doors are closed
properly.
Make sure that there is not a damaged fuse in the fuse
box.
Make sure that the Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the
end of countdown.
Deactivate the Child Lock function if it is on.
WARNING!
Make sure that the
temperature is more than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance does not drain the
water.
- The appliance lid or drum doors
are open or not closed correctly.
Please check both!
flashes in red 11 times and 1 (or 2 or
3) time(s) in yellow: the mains supply
is unstable. Wait until the mains
supply is stable and the appliance
automatically starts operating.
WARNING!
Deactivate the appliance
before you do the checks.

Advertisement

loading

  Related Manuals for Electrolux EWT 0862EWW