Table of Contents
Advertisement
Problem
The hob deactivates.
One pot activates two
zones.
Two or more zones are de‐
tected as one zone.
There is no pot indication
on the flexible zone.
Power Boost is not activat‐
ing for the pot on the flexi‐
ble zone.
Heat settings for the pots
on flexible zone are re‐
duced.
comes on.
Pro Cook function deacti‐
vates.
Possible cause
The fuse is blown.
There is water or fat stains
on the control panel.
You put something on the
sensor field
.
The pot bottom is uneven.
The pots are too close to
each other and the cooking
zones were not set after
placing each pot.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too
small for the zone.
There is already cookware
on the zone.
The pot is bigger than 240
mm. The maximum power
is reached.
You are using to many
pots with the highest heat
setting on the flexible
zone. Power management
function is activated.
One of the Lock functions
is active.
You are using more than
one pot.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Clean the control panel.
Remove the object from
the sensor field.
Move the pot slightly until
only one zone is detected.
For every pot set the zone
individually after placing
the pot on the cooking
zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical infor‐
mation" chapter.
Move the first pot slightly to
make room for the next
one.
It is normal for this size of
pot. Use smaller pot or use
the highest heat setting for
the big one.
Move some pots to induc‐
tion cooking zones.
To unlock the hob touch
letters in alphabetical order
A - O - X.
Use only one pot for the
function.
17
Advertisement
Table of Contents
