17x11 bleed template; DragonNotice; large text
Safety Guidelines
This section contains notices that you have to adhere to
ensure your personal safety and to prevent any damage to
the equipment.
Qualified Personnel:
Electrical Hazard: Only qualified personnel should perform
installation procedures. Within the context of the safety notes in
this documentation qualified persons are defined as persons who
are authorized to commission, ground and label devices, systems
and circuits in accordance with established safety practices and
standards. A qualified person understands the requirements risks
involved with installing outdoor electrical equipment in accordance
with national codes.
Grounding Warning:
Warning: To operate the Enterasys Wireless Outdoor AP3660
safely, the chassis ground connector must have a suitable cable
connected. Do not use the Enterasys Wireless Outdoor AP3660
without a ground cable connected.
Lightning Protection Warning:
Warning: Antennas installed outdoors must be within the area
covered by a lightning protection system. Make sure that all
conducting systems entering from outdoors can be protected by a
lightning protection potential equalization system.When
implementing your lightning protection concept, make sure you
adhere to the VDE 0182 or IEC 62305 standard.
The AP3660 has a built-in lightning protector; no external lightning
protector is required. You must however note that the lightning
protector is not an adequate protection against a lightning strike.
The lightening protector only works within the framework of a
comprehensive lightning protection concept. If you have
questions, ask a qualified specialist company.
Supplement to Product Instructions
(Hazardous Substance)
(Parts)
(Metal Parts)
Circuit Modules)
Cables & Cable Assemblies)
(Plastic and Polymeric parts)
Circuit Breakers)
SJ/T 11363-2006
Indicates that the concentration of the hazardous substance in all homogeneous materials in the parts is
below the relevant threshold of the SJ/T 11363-2006 standard.
SJ/T 11363-2006
Indicates that the concentration of the hazardous substance of at least one of all homogeneous
materials in the parts is above the relevant threshold of the SJ/T 11363-2006 standard.
This table shows where these substances may be found in the supply chain of Enterasys' electronic
information products, as of the date of sale of the enclosed product. Note that some of the component types
listed above may or may not be a part of the enclosed product.
The Environmentally Friendly Use Period (EFUP) for all enclosed products and their parts
are per the symbol shown here, unless otherwise marked. Certain parts may have a
different EFUP (for example, battery modules) and so are marked to reflect such. The
Environmentally Friendly Use Period is valid only when the product is operated under the
conditions defined in the product manual.
Hazardous Substances
This product complies with the requirements of European
Directive, 2002/95/EC, Restriction of Hazardous Substances
(RoHS) in Electrical and Electronic Equipment.
European Waste Electrical and Electronic
Equipment (WEEE) Notice
In accordance with Directive 2002/96/EC of the European
Parliament on waste electrical and electronic equipment (WEEE):
1. The symbol above indicates that separate collection of electrical
and electronic equipment is required and that this product was
placed on the European market after August 13, 2005, the date
of enforcement for Directive 2002/96/EC.
2. When this product has reached the end of its serviceable life, it
cannot be disposed of as unsorted municipal waste. It must be
collected and treated separately.
3. It has been determined by the European Parliament that there
are potential negative effects on the environment and human
health as a result of the presence of hazardous substances in
electrical and electronic equipment.
4. It is the users' responsibility to utilize the available collection
system to ensure WEEE is properly treated.
For information about the available collection system, please go
to www.enterasys.com/services/support/
Customer Support at 353 61 705586 (Ireland).
Declaration of Conformity
A "Declaration of Conformity" in accordance with the preceding
directives and standards has been made and is on file at Dell Inc.
Products Europe BV, Limerick, Ireland.
Notice
Enterasys Networks reserves the right to make changes in
specifications and other information contained in this document
and its Web site without prior notice. The reader should in all
cases consult Enterasys Networks to determine whether any such
changes have been made.
The hardware, firmware, or software described in this document
is subject to change without notice.
IN NO EVENT SHALL Enterasys Networks BE LIABLE FOR
ANY INCIDENTAL, INDIRECT, SPECIAL, OR
CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING
BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR
RELATED TO THIS DOCUMENT, WEB SITE, OR THE
INFORMATION CONTAINED IN THEM, EVEN IF Enterasys
Networks HAS BEEN ADVISED OF, KNEW OF, OR SHOULD
HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.
Enterasys Networks, Inc.
50 Minuteman Road
Andover, MA 01810
50
© 2010 Enterasys Networks, Inc. All rights reserved.
Part Number: 9034581 September 2010
ENTERASYS and ENTERASYS NETWORKS and any logos
associated therewith, are trademarks or registered trademarks of
Enterasys Networks, Inc., in the United States and/or other
countries. For a complete list of Enterasys trademarks, see http://
www.enterasys.com/company/trademarks.aspx.
All other product names mentioned in this document may be
trademarks or registered trademarks of their respective
companies.
or contact Enterasys
Enterasys Wireless
Outdoor Access Point
Quick Reference
AP3660
P/N 9034581