Table of Contents
Advertisement
3.4.9
Decimal Separator
The Decimal Separator feature allows you to decide between dot (.) or comma (,) as a decimal
separator for the decimal numbers.
3.4.10
Test Unit
The Test unit feature allows you to test your device. It's intended to be used mainly for
Datamars support team.
3.4.10.1 Autotuning RFID (For Datamars support only)
The Autotuning RFID test shows the values of tuning position and power
3.4.10.2 Cyclic Delay (For Datamars support only)
This feature allows changing the time duration of one reading cycle. The Cyclic Delay has to
take longer than the Reading Timeout.
3.4.10.3 Cyclic Reading (For Datamars support only)
This feature starts the reading cyclic test, that is based on:
- Reading time
- Pause
3.4.10.4 CNT Reading (For Datamars support only)
This feature starts a reading test and indicates the percentage of the readings done.
3.4.10.5 Save RF (For Datamars support only)
This feature allows saving information about RF analogic signal.
GES3S Manual – v. 1.9 March 2017
27
Advertisement
Table of Contents
