Customer Service; Assembly Instructions - Peg-Perego CD 0517 Use And Care Manual

PEG PEREGO ® thanks you for choosing this product.
For over 50 years, PEG PEREGO has been taking
children for an outing: first with its famous baby
carriages and strollers, later with its pedal and
battery operated toy vehicles.
Read this instruction manual carefully to learn
the use of this vehicle and to teach your child
safe and enjoyable driving. Please keep this
manual for use as a reference in the future.
Our toys conform with the safety
requirements provided by the Council
of the EEC, of the T.Ü.V; and the U.S.
TUV ¨
Consumer Toy Safety Specification
PRODUCT
F963.
SERVICE
Peg Perego reserves the right to modify or change
their product. Price, literature, manufacturing
processes or locations or any combination of these
above mentioned entities may change at any
time for any reason without notice with impunity.
Years 3-6

CUSTOMER SERVICE

PEG PEREGO offers after-sales services, directly or
with a network of authorized service centers (see
enclosed) for repairs or replacement parts.
EUROPE: 0039·39·6088213
0039·39·6088299
USA: 1·800·728·2108
1·800·225·1558
MEXICO: 1·800·225·1558
CANADA: 1·800·661·5050
call us toll free
llame gratis
llame gratis
call us toll free

ASSEMBLY INSTRUCTIONS

ADULT ASSEMBLY REQUIRED.
USE CARE WHEN UNPACKING AS COMPONENTS TO BE
ASSEMBLED MAY POSE A SMALL PARTS/SHARP EDGE
HAZARD.
ASSEMBLY
1 • Insert the fake counterweight at the front
of the tractor.
2 • Tighten the screw in the base.
3 • Connect the two parts of the steering
wheel.
4 • Attach the steering wheel with the proper
screw and nut.
Note: nut fits into hexagon hole, screw
into round hole.
5 • Remove the stud from the bucket arm.
6 • Before positioning the arm, apply the decal
#5 and #5 .
L R
Position the arm on the motor and re-insert
the stud.
7 • Fasten the tie rod with the stud by placing
a retainer on the rod and pressing firmly
at both ends.
8 • Remove the tape.
9 • Insert a retainer in the special device.
Insert the shovel rod in the hole on
the command lever. Fasten the shovel tie
rod with the stud as shown in the figure.
10 • Insert the plugs in the handlebar.
11 • Insert and fit the handlebar with the
screws provided.
12 • To lower the entire bucket block, push
the handle forwards.
13 • To tip the shovel, lower the command
lever.
14 • Position the roll-bar to the fender.
15 • Tighten the four screws to fix the roll-bar.
16 • Position and screw on the fender with
the 4 screws.
17 • Attach SMV triangle to tractor with two
screws.
18 • Unscrew the two knobs and plate from
seat bottom.
19 • The seat can be set at two different positions
depending on the height of the child.
20 • Position the seat in one set of the holes.
21 • Place the tractor on its side and unscrew
the panel on the bottom.
22 • Insert the steel plate and hook it onto
the threaded pins of the seat.
23 • Tight the seat with the two knobs and
screw the panel back in place.
24 • Position the roll-bar lights (1), pushing
them till they click (2).