Advertisement
TAC Xenta 511 and 911 Handbook
3.3.4 Connecting a PC to the TAC Xenta 911 via a LAN
3.3.5 System Configuration
20 (32), 0-004-7870-0 (EN)
• Domain name
• Host name
4 Change root password (immediately or later, using passwd)
5 "Do you want to restart the IP interface?"
• yes will make the changes effective immediately
• no will make the changes effective after the next 911 restart..
6 Exit by typing lo (log out) and pressing Enter.
1 Connect the Xenta 911 to a LAN according to the figure below.
2 Connect the PC to the same network and start the PC HTML
browser (for example Internet Explorer).
LAN
10 Mbps patch
UTP or STP cable
LAN = Local Area Network
UTP = Unshielded Twisted Pair
STP = Shielded Twisted Pair
Connecting the TAC Xenta 911 to a Local Area Network
3 Enter the IP address for the Xenta 911 (e.g. http://172.20.4.21).
4 Log in as root and use the valid password. This should get you to
the Welcome page of the Xenta 911.
When you log in as root and use the valid password you will get to the
Welcome page of the Xenta 911. From here you can start the Setup Wiz-
ard.
MMC
A RS232 B
10Base-T
TAC AB, 16 May 2003
3 TAC Xenta 911
Advertisement
