Front Panel - M2TECH VAN DER GRAAF MKII User Manual

VAN DER GRAAF M II
K
VERY LOW NOISE POWER SUPPLY
REVISION P B – AUGUST 2017
R

2. Front Panel

1) Power on LED. It's on when the VAN DER GRAAF M
2) Global enable button. Push this button to activate the VAN DER GRAAF M
standby (LED 1 on and LED 3 off). Following the operation of this button, all outputs
previously enabled by the user with their buttons (item 4, Fig. 1) will activate, in the same
sequence as the user manually activated them, with 1 second intervals. The related LED's
will turn on to indicate activation. During the process, LED 3 blinks. At the end of activation
process, LED 3 glows steadily. When the VAN DER GRAAF M
VAN DER GRAAF M II in standby, disabling the outputs in reverse order with regards to
k
activation, by pushing this button. In the process, LED 3 blinks. At the end of disable
process, LED 3 turns off.
3) Global enable LED. It's on when the VAN DER GRAAF M
enabling and disabling outputs.
4) Single output enable buttons. When the VAN DER GRAAF M
3 on), it is possible to toggle each output by pushing the related button.
5) Single output enable LED's. Each LED is on when the related VAN DER GRAAF M
output is enabled.
6) IR receiver. The VAN DER GRAAF M
products' remote controls, when purposely set by the user. Operation is same as the
global enable button (item 2, Fig. 1).
Figure 1
II is powered.
k
II senses the on/off commands from other M2Tech
k
9
M2Tech
www.m2tech.biz
II when it's in
k
II is active, user may put the
k
II is active. It blinks when
k
II is active (both LED 4 and
k
Copyright © 2017, M2Tech Srl
II
k