Function Setting; Temperature Setting; Timing Function - Pelonis NTH15-17MR Owner's Manual

OPERATING INSTRUCTION
Check before turning on the machine
1. Check if the power wire is under good condition.
2. The product adopts 120V AC power supply, before use, please confirm if
the rated current of the power socket meets the local requirements with safe
grounding device, otherwise, please replace it with the qualified socket.
Start the machine
Plug the unit into a grounded 120V outlet, press the ON/OFF key (or press the
ON/OFF key of the remote controller) for start, the machine supplies air at high
power after start,the display will show the temperature of 95°F.

Function setting

Repeatedly press the "Function" key so that the heater switches in the order of
"high gear - low gear - fan - ECO mode - high gear".

Temperature setting

In the working state of the machine, press "+" or "-" can set the temperature
value, set the range of 41-95°F.When the room temperature reaches the set
temperature, the display flashes 10S, the machine stops working. In the standby
state, when the temperature is lower than the set temperature, the machine
starts to heat up again.

Timing function

Timing stop
When the heater is turned on, press the TIMER key to enter the timing stop
state (within 0-24 hours), then press the "+" key to increase the timing stop time
by 1 hour once, and press the "-" key to decrease the timing stop time by 1 hour
once.
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter
the reservation start mode (within 0-24 hours), then press the "+" key to increase
the reservation start time by 1 hour once, and press the "-" key to decrease the
reservation start time by 1 hour once.
Swing function
The electric heater in operation mode, press the "swing" key to open the swing
function, pressing this button to turn off the swing function; when the electric
heater stops heating function, the wind swinging function also stop.
4