1. Manuals
  2. Brands
  3. BN Products Manuals
  4. Cutter
  5. DBS-16H
  6. Operating and safety instructions manual

BN Products DBS-16H Operating And Safety Instructions Manual

Rebar bender
Hide thumbs Also See for DBS-16H:
Table of Contents

Advertisement

Quick Links

Download this manual
OPERATING/SAFETY
ORIGINAL INSTRUCTIONS
DBS-16H
REBAR BENDER
TO REDUCE THE RISK OF INJURY, YOU MUST READ
AND UNDERSTAND THESE INSTRUCTIONS
Products that make money, save money and add value to your bottom line

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DBS-16H and is the answer not in the manual?

Questions and answers

Related Manuals for BN Products DBS-16H

Summary of Contents for BN Products DBS-16H

  • Page 1 OPERATING/SAFETY ORIGINAL INSTRUCTIONS DBS-16H REBAR BENDER TO REDUCE THE RISK OF INJURY, YOU MUST READ AND UNDERSTAND THESE INSTRUCTIONS Products that make money, save money and add value to your bottom line...

  • Page 2: Work Area Safety

    GENERAL SAFETY RULES Do not abuse the cord. Never use the cord for car- rying, pulling or unplugging the power tool. Keep WARNING: PLEASE READ AND UNDER- cord away from heat, oil sharp edges or moving STAND ALL INSTRUCTIONS. parts. Damaged or entangled cords increase the risk of electric shock.

  • Page 3: Specific Safety Rules

    Do not overreach. Keep proper footing and bal- Store idle power tools out of the reach of children ance at all times. This enables better control of the and do not allow persons unfamiliar with the power tool in unexpected situations. power tool or these instructions to operate the power tool.

  • Page 4: Extension Cords

    Do not use the tool if the cord or plug is damaged. or three wire extension cord. As the distance from If damaged, have it repaired by a BN Products- the supply outlet increases, you must use a heavier USA service facility before use. If the plug will not gauge extension cord.

  • Page 5: Specification

    360° Rotatable between motor and pump case SPECIFICATION: MODEL DBS-16H Power Supply 110V / 115 /230V AC only Wattage 1020W Motor Double insulated motor Max. rebar dia. 16mm (5/8”) Bending speed 4 - 5 sec. Bending radius R.31.0 mm Max. tensile strength...
  • Page 6 110V, 115V or 230V 50/60Hz. (Check the 5. Check and keep work area clean and enough voltage of your DBS-16H.) work space. WARM UP 6. Check condition of bending roller, center...

  • Page 7: Points Of Attention

    STOPPER BOLT ADJUSTMENT In the event that bending ann (roller) should fail AND BENDING to return automatically for any reasons (e.g. the bending arm (roller) has become jammed), tum The stopper bolt functions to maintain the rebar in the release lever to OPEN position. Make sure the the correct position during bending and must be release lever is in CLOSE position before resuming properly set for each size of rebar before bending.

  • Page 8: Oil-Level Check (Add Oil)

    CLEANING physician. In case of skin contact, wash thoroughly with soap and water. In case of ingestion, consult a Clean your tool every day, preferably immediately physician immediately. after use. Do not induce vomiting. WARNING: To avoid accidents always disconnect the tool from the power supply before cleaning or 1.

  • Page 9: Carbon Brushes

    CARBON BRUSHES OVERHAUL Inspect the two carbon brushes at least once every Return the unit to an authorized distributor for two months. (Nominal brush life is 200 hours). overhaul at least once every two years, sooner if subject to heavy use. Ignorance of proper operat- ing procedures can lead to accidents.

Table of Contents