TDR Spider Instruction Manual page 8

Binding drone to the controller
1. Fully insert battery into drone unit and place on level surface
2. When 4 LEDs flash rapidly, the drone is ready to bind
3. Turn on the controller by switch the power switch to "ON"
4. Push the left stick up then down
6. LEDs on the drone will stop flashing after binding has been successful
Fully insert battery
Start the motors
After blinding, you can push the Throttle Stick up slightly to start the motors for takeoff.
To land, push the Throttle Stick down slowly until the drone lands and motors stop.
Takeoff
08
Power On
Turn on the controller
Land
Push the left stick
up, then down