Table of Contents
Advertisement
Calibration and master reset
Gyroscope Calibration
The built-in gyroscopic sensor measures the angular velocity and the orientation of the drone.
A calibration may be necessary after shipping or a hard landing. It's a good idea to calibrate
you drone if it is veering off to one side or not flying properly.
1. Bind the drone to the controller.
2. Place drone on a flat and level surface
On the controller, spin the right stick 360°,
clockwise.
3. All 4 LED lights on the drone will flash for
a few seconds, notifying you that calibration
was successful.
Factory Reset
Performing a factory reset will reset all the current settings, including the trim and the
gyroscope calibration, back to the factory settings.
1
1. Bind the drone to the controller
2. Place the drone on a flat and level
2
surface.
3. Short press the trim button.
4. Spin the right stick 360° clockwise
5. Once complete, all settings will be factory
reset.
15
Advertisement
Table of Contents
