TDR Spider Instruction Manual page 7

Charging and installing battery for the drone
1. Connect the battery to USB charging cable.
2. Connect the USB charging cable to USB power
source.
3. The LED light will be on while charging, and off
once charging completed.
4. Insert the battery in to the battery chamber of the
drone and connect the connector terminal.
LED Charging Status Indicators
On - Charging the battery
Off - Charging complete
Charging Time: approx 60min
Fly Time: approx 5min per charge
Charging and installing battery for the controller
1. Unscrew the screws on the battery chambers
behind the controller.
2. Slide out the battery chamber cover.
3. Insert 4 pieces of AAA batteries (2 for each side).
4. Close the battery chamber, put the screw back on.
Cautions:
• Use only 1.5V AAA type batteries.
• Insert batteries with correct polarity (mind the + and - sign).
• Non-rechargeable batteries should not be recharged.
• Rechargeable batteries should only be charged under supervision.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (NiCD/NiMH) batteries.
• Remove batteries when they are used up.
• Never throw batteries in the fire or attempt to open its outer casing.
07
Charge the battery for the drone
Insert the battery into the drone