Troubleshooting - TDR Spider Instruction Manual

Troubleshooting

Problem/Issue
Cannot bind drone to
1
controller
2 Drone does not turn on
3 Controller does not turn on
Blades do not spin or
drone has difficulty taking
4
off the ground, LEDs are
flashing
Unstable drone flying /
5
strong vibration
All blades spin but drone
does not take off the
6
ground or not flying
properly
Drone crashes
7
immediately
Drone can not perform
8
360°/180° Roll
Drone can not perform the
9
Stunts
18
Cause
a) Battery
b) Electromagnetic interference
c) Out of range
a) Battery too low
b) Battery not fully plugged in
a) Switch didn't turn on
b) Battery didn't install correctly
c) Battery power too low
Battery power level is too low
a) Damaged blade(s)
b) Gyroscope needs calibration
Blades are not installed correctly
Blades are not installed correctly
Battery power level is too low
Drone is not in 180° Rolling
mode
Soluction
a) Make sure the batteries in both drone and
controller are fully charged
b) Clear out objects between drone and controller
c) Put drone and controller closer to each other
a) Charge battery
b) Battery fully plugged in the correct direction
a) Ensure switch is turned on
b) Ensure battery fully plugged in correctly and
securely
C) Charge the battery
Fully recharge the battery
a) Replace the blade(s)
b) Calibrate the gryoscope (page 15)
Reinstall the blades following the "Blade
Installation" section on page 14
Reinstall the blades following the "Blade
Installation" section on page 14
Fully recharge the battery
Short press MFB once switch to 180° Rolling
mode (page 11).