Huffy GREEN MACHINE Owner's Manual page 4

Helmet Warning Information
WARNING:
ALWAYS WEAR YOUR
HELMET WHEN RIDING
THIS PRODUCT!
• Helmet should sit level on your head and low on your
forehead. Exposed forehead can result in serious injury.
• Adjust the strap sliders below the ear on both sides.
• Buckle the chin strap. Adjust strap until it is snug.
• No more than two fi ngers should fi t between the strap and
your chin.
• A proper fi tting helmet should be comfortable and not rock
forward/backward or side to side.
Radio Frequency Information (charger/adapter)
CAUTION
: Changes or modifi cations
to this unit not expressly approved by the
party responsible for compliance could
void the user's authority to operate the
equipment.
This device (charger/adapter) complies with
Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
4
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit diff erent from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Troubleshooting Guide - continued
Problem Possible Cause
Vehicle will not Poor contact of wires or
run when Switch is connectors
pressed.
"Dead Spot" on motor
Loud grinding or Motor or gears are dam-
clicking noises aged
coming from motor
Drive Wheel is partially
or gear box
engaged
Battery will not Battery connector or
recharge adapter connector is
loose
Charger not plugged in
Charger is not working
Battery is dead
Charger feels warm This is normal and not a
when recharging cause for concern
Solution
Check that the battery connectors
are fi rmly plugged into each other. If
wires are loose around the motor call
Customer Service.
A dead spot means the electric power
is not being delivered to the terminal
connection and the vehicle needs
repair. Call Customer Service.
Call Customer Service.
Check drive wheel - to motor engage-
ment.
Check that the battery connectors are
fi rmly plugged into each other.
Check that the battery charger is
plugged into a working wall outlet.
Replace battery.
If excessively hot, unplug and replace.
29