Advertisement
ASSEMBLING 4
● If it s too tight to fit each groove and frame, enlarge the groove
with a file before gluing the deck with frame.
● Insert the frame ⑧,⑨ in the grooves of ⑫,⑬ and ⑪ and glue
them on the stern of the deck ⑳, using 3 . Glue ⑭ and ⑮ with
1 or 2 .
※Be careful not to make ⑮ upside down or left-right reversal.
TOP
BOTTOM
Hole for the Front rudder
Hole for the Rear rudder
1 Instant adhesive 2 5-minute Epoxy adhesive 3 30-minute Epoxy adhesive 4 6-hour Epoxy adhesive
● Glue ③ to the frame ④ with 1 . The part ③ is used to make
the deck corners round.
● Glue the frames ④,⑤,⑥,and ⑦ to the bottom of the hull in
this order, and together with the deck ② using 4 .
● The periphery of the deck is recommended to be fastened
with clips as shown. The frame ④ and the deck ⑳ must be
held with 2 pieces of bars and a string.
※Fill undesigned hollows with 4 .
Fill such hollows
(Hatching area) with 4
Frame
Adhesive
Hull
String
NO 5
Clip
Bow
Large
R fillet
Bring the
corner into line
Bar
Advertisement
