ASSEMBLING 11
15x15 square bar cut to
about 122mm in length
on which the engine bed will mount
● Two sheets of 16 are prepared by gluing using 2 , 3 , and
are glued to either side of the inside of 12 , and frame 7
Frame
using 2 , 3 .
● Two cypress square bars 15x15 cut to about 122mm
lengths are placed into the grooves of 16 and glue them
using 2 , 3 .
● 3 pieces of 17 are pasted together, to make an engine bed
using 2 , 3 .
● The engine bed 17 is mounted on 15x15 cypress square
bars by 4 tapping screws, therefore do not glue it at the
moment.
※ The bottom of the ship has now been tentatively completed.
※ Fill each clearance between frames and FRP hull with epoxy
adhesive. Die-cut parts should be touched with woodworking
or epoxy putty.
※ 8 in the left drawing shows the shape of after cutting frame.
1 Instant adhesive 2 5-minute Epoxy adhesive 3 30-minute Epoxy adhesive 4 6-hour Epoxy adhesive
NO 12