Acer Altos G530 Series User Manual page 58

48
(2) Attach the system's power cable to the SATA power cable
connector on the backplane board (2).
Note: The SATA RAID data cables must be installed and removed
in the following order: SATA0, SATA1, SATA2, then SATA3.
6 Observe the post-installation instructions described on page 36.
Important: When you are removing the hot-plug cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, see "Installing an additional hard disk into the
HDD cage carrier" on page 53.
7 Change the RAID configuration of your hard disk. For details on
how to change the RAID configuration of your hard disk, go to
"Appendix C: SATA RAID configuration" on page 167.
3 System upgrade