Test Strip - Active Care Medical TD-4121 Owner's Manual

Test Strip

Absorbent Hole
Apply a drop of blood here.
The blood will be automatically absorbed.
Confirmation
Window
This is where you confirm
if enough blood has been
applied to the absorbent hole in
the test strip.
Contact Bars
Insert this end of the
test strip into the meter.
Push it in firmly until it will
go no further.
Attention

The front side of test strip should face up when you insert test
strip.

Test results might be wrong if the contact bar is not fully
inserted into the test slot.
Setting:
Set up date, time, reminder alarm, measuring units,
displayed languages and so on.
You may also turn on/off airplane mode from here.
Calling:
Call out to the service center or answer phone calls. This
function activates for only 10 minutes after each
measurement, allowing the service center to contact with
users directly.
Test Strip Handle
Hold this part to insert the
test strip into the slot.
12