Hoover DXC 27/1-AUS Manual page 12

button is pressed, until h24 appears on
the display, at which point pressing the
button again will reset the delay start to
zero.
- Confirm by pressing the START/PAUSE
button (the light on the display starts to
flash). The countdown will begin and
when it has finished the programme will
start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to OFF.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF.
The option buttons should be selected
before pressing
button.
If an option
not compatible
programme then the option indicator
first flashes and then goes off.
PREWASH button
It allows you to do a preliminary wash at the
beginning of the cycle. The temperature does
not exceed 40°C and in any case it does not
exceed the maximum temperatures of the
selected washing program (ex. the temperature
of HAND program will be 30°C.
EASY IRON button
This function allows you to minimizes
creases as much as possible, eliminating
the intermediate spins or reducing the
intensity of the last one.
the START/PAUSE
is selected that
with the selected
SPIN SPEED button
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
l
To reactivate the spin cycle press the button
until you reach the spin speed you would
like to set.
To prevent damage to the fabrics, it is
not possible to increase the speed
over that
suitable during the selection of the
program.
l
It is possible to modify the spin speed
without pausing the machine.
The machine is fitted with a special
electronic device, which prevents the
is
spin cycle
unbalanced.
This reduces the noise and vibration in
the machine and so prolongs the life of
your machine.
TEMPERATURE SELECTION
button
When you select a program, the light
illuminates the recommended temperature.
It is also
temperature but not over the maximum in
order to save the fabrics.
RAPID LENGTH button
The button becomes active when you select
the RAPID program on the knob; it allows you
to select one of three durations indicated.
12
which is automatically
should the load
possible to change
be
the