Tower Assembly; Tower Tube Layout - Primus Wind Power EZ Tower Owner's Manual

TOWER ASSEMBLY

The tower is assembled in several easy steps. If this is a permanent instal-
lation, first dig a trench from the base of the tower, to where the battery is
housed.

Tower Tube Layout

1. Lay out the six tower tubes on the ground as shown on the following
page. Leave approximately 6 in (15 cm) between each tube.
16 EZ Tower Owner's Manual, Rev A
TM
42 in (1.0 m) Top Tower Tube
72 in (1.8 m) Tower Tubes
4- 72 in (1.8 m) tubes
between top & bottom tower
Location for 21 ft (6.4 m)
guy wire attachment plate
48 in (1.2 m) Bottom Tower Tube
Location for 30 ft (9.1 m)
guy wire attachment plate
Guy Wire
Attachment
Plate
42 in (1.0 m)
72 in (1.8 m)
72 in (1.8 m)
72 in (1.8 m)
72 in (1.8 m)
48 in (1.2 m)
Note: Drawings not to scale.