Downloading The Configuration To The Plc - Raco Catalyst Addendum To Owner's Manual

In this dialogue we will enter a value for the time between each scan of the module. In this example, we have set
the interval to 50 ms to reduce the network load. Make sure that "Inhibit Module" isn't checked. After this, press
finish.
Now the Catalyst has been added to the I/O configuration in RSLogix 5000. The main screen will look as
follows.
Figure 10 The main screen when the configuration is completed.
8.3.

Downloading the configuration to the PLC

First select the communication path. This can be done by opening the Communications menu and selecting the
Who Active command. Select the desired communication path as seen below.
Figure 11 Configuring the communication path.
Saved: 2014-06-18
Filename: Catalyst Ethernet Addendum 1 1 V1_5 released
RACO Manufacturing and
Engineering
Page 15 (21)