Then enter the desired settings and press finish.
Figure 5 Configuring the settings for the Ethernet module.
8.2.
EtherNet/IP network configuration
The second step is to configure the EtherNet/IP network and adding the RACO Catalyst EtherNet/IP module to
the configuration in the PLC. Begin with setting the program in "Offline" mode. Then right click on the
EtherNet/IP Bridge in the I/O configuration, and select "New Module".
1
Figure 6 Adding the Catalyst module.
Saved: 2014-06-18
Filename: Catalyst Ethernet Addendum 1 1 V1_5 released
2
RACO Manufacturing and
Engineering
Page 12 (21)