Advertisement
4
Notice
.Compliance Information Statement
FCC WARNING
This equipment generates or uses radio frequency energy.
Changes or modifications
to
this equipment may cause harmful
interference unless the
modifications
are expressly approved in the
instruction manua l.
The
user could
lose
the authority to operate this
equipment 汗 an
unautthorized change or modification
is
made
INFORMATION TO THE DIGITAL DEVICE USER
REQUIRED BY THE FCC
This
equipment
has
been
tested
and
found to
comply with
the
limits for a
Class B
digital
device
,
pursuant to Part
15
of the FCC Rules
These
limits are designed to provide
reasonable
protection against
harmful interference in a residential installation.
This equipment generates
,
uses and can generate radio frequency energy
and
,
if
not installed and
used
in accordance with
the
instructions
,
may
cause harmful
interference
to radio communications. However. there
is
no
guarantee
that the
interference will not occur in a
particular installation. If
this
equipment
does
cause harmful
interference
to radio or television
reception
,
which can be determined by
turning
the equipment off and on
,
the
user is encouraged
to
try to correct
the
interference by one or more of
the following measures
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on
a
circuit different
from
that to
which
the
receiver is connected
• Consult
the
dealer for technical assistance.
CE
Conformity Information
In case the unit you have purchased
is
marked with a CE
symbol
,
a copy of relative conformity certificate or
document
can be
reviewed
at
h忧p:llwww.alinco.com/usa.html.
• RADIO FREQUENCY ENERGY SAFETY
INFORMATION
Notice
This Alinco
transceiver has been tested and complies with the standards
listed
below
,
in
regards to Radio Frequency (RF) energy and electromagnetic
energy (EME) generated by
the transceiver.
•
FCC RF exposure
limits for
Occupatiοnal
Use Only. RF Exposure limits
adopted by the
FCC
are generally
based
on
recommendations
from the
National Council on Radiation Protection and Measurements
,
and
the
American National Standards Institute.
•
FCC OET Bulletin 65 Edition 97-01 Supplement C
• American National Standards
Institute
(C95.1
- 1992)
• American National Standards
Institute
(C95.3
- 1992)
卢Aw.川咱
ThisAI 川inco
transceiver generates RF EME while
t 廿 ra 门 smit 创 tin 、 g.
RF EME
(Radio Frequency Electric and
Magnetic
Energy) has the potential
to
cause slight thermal
,
or
heating
e仔ects
to any
part
of your body less than
the
recommended
distance from
this radio transmitter's antenna. RF
energy exposure
is
determined primarily
by the
distance
to
and
the
power
of the
transmi忧ing
device.
In
general
,
RF exposure is minimized when the
lowest possible power is used or
transmission time
is kept to the minimum
required for consistent communications
,
and the greatest distance
possible from the antenna to the body
is
maintained. The transceiver has
been
designed
for and is classified for Occupational
Use
Only.
Occupationall controlled exposure limits are applicable to situations in
which persons
are
exposed to RF energy as a consequence of
their
employment
,
and such persons have been made aware of the potential for
exposure and can exercise control over their exposure. This means you
can use the transceiver only
if
you are aware of the
potential
hazards
of
operating a
transceiver
and are familiar in ways to minimize these
hazards.
This
transceiver is not intended for use by the general public in
uncontrolled environments.
Uncontrolled
environment
exposul
r e limits are
applicable to situations
in
which the general public may be exposed to RF
energy
,
or in which the
persons
who are exposed as a consequence of
their employment may not be
fully
aware of the potential for exposure or
cannot exercise <:ontrol over their exposure.
5
Advertisement
