Kenmore 110.3316 series Use & Care Manual page 6

OPTIONS
6
You may add or remove options for each cycle. Not all
options can be used with all cycles, and some are preset
to work with certain cycles.
ACCELA WASH
Adding this option reduces the cycle time while
maintaining a wash performance similar to the same
cycle without ACCELA WASH.
DEEP FILL
If you would like to add the maximum amount of water to
your wash cycle, select the Deep Fill option.
NOTE: Expect longer cycle times due to extended fill
times when using the Deep Fill option.
STEAM TREAT
The Steam Treat option adds additional soak and wash
time to many cycles to help remove tough stains, as well
as a steam boost for added cleaning power. Steam Treat
uses a heater within the washer to maintain the selected
temperature setting throughout the wash period. Steam
Treat may be selected as an option with other cycles.
NOTE: The Steam Treat option may increase the selected
temperature.
TIMED OXI
This option must be selected if using Oxi products during
a cycle. It ensures that the Oxi product is added at the
correct time in the cycle for even distribution.
TWO RINSES
This option can be used to automatically add a second
rinse to most cycles..
FABRIC SOFTENER
This option must be selected if using fabric softener during
a cycle. It ensures that fabric softener is added at the
correct time in the rinse for even distribution.
6
CYCLE STATUS LIGHTS
7
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
DELAY
When Delay Wash has been selected, the Delay
light will illuminate and remain illuminated until the
cycle begins.
ADD A GARMENT
When Add A Garment is lit, you may pause the washer,
open the lid, and add items. Touch and hold START/
PAUSE/Unlock Lid to start the washer again.
WASH
During the first stage of the wash cycle, water will
partially fill the washer and begin to move the load.
You will hear the impeller rotate followed by a several
second pause. This process will repeat for several minutes,
allowing the entire load to become saturated. It is normal
for the load to be above the water line during this stage.
At the beginning of the second stage, the washer will add
water to the correct level based on the load size. You will
hear the impeller increase speed during this stage of the
wash cycle. The motor sounds may change at different
stages in the wash cycle.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly (short hum) to move the basket
while filling.
SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle and
spin speed.
COMPLETE
Once the cycle is complete, this light will come on. For
best results, promptly remove the load.
LID LOCKED
The Lid Locked feature allows for
higher spin speeds. When lit, the lid is
locked and cannot be opened without
pausing the cycle. When the light is off,
the lid can be opened.
To open the lid after it has been locked,
press START/PAUSE/Unlock Lid. The
lid will unlock once the washer movement has stopped.
This may take several minutes if the load was spinning at
high speed. Press START/PAUSE/Unlock Lid while the lid is
closed to resume the cycle.