Mounting The Odu; Using The Clamp - Gemtek Systems CPE7000 Quick Installation Manual

CPE7000 Outdoor Dual Mode - Quick Installation Guide

Mounting the ODU

Mount the ODU unit on a 1"-4" pole using the supplied kit (Figure 1), or the optional Tilt accessory.

Using the Clamp

1 Tread the M10*100mm bolt through a spring washer, flat washer and the bracket holes.
2 With the connector facing downward, attach the ODU to a 1" -4" pole.
3 Attach the bracket to the other side of the pole.
4 Thread the M10*100 mm bolts through both holes on either side. Tighten the nuts.
 
Figure 1: Mounting the ODU on the Pole

