Mounting - Senor Tech iSPOS User Manual

SENOR TECH CO., LTD.
Clearances The iSPOS terminal should be located where there is
adequate clearance for ventilation around the terminal. Similarly, clearance
around the power supply for ventilation, as well as access to the power
switch, indicators and connectors should be allowed for. Additional
consideration should be given to ensuring nothing can be placed over the
fan or vent holes, e.g. paper, rags etc.
Cable Routing In most cases the position of printers, scanners etc. will
make it necessary that the cabling will have to be run through counter
dividing panels and shelves. Try to keep these runs as short as possible,
while avoiding stretching or crimping the cable. Keep the iSPOS data
cables separated from those for other equipment, in particular motors,
lighting, refrigeration etc.
Mains AC Power Supply AC supply to the iSPOS system should be a
dedicated feed from the main switchboard. Do not connect any other
equipment to this feed or damage to the iSPOS terminal or its peripherals
may result. A hint is to clearly identify each iSPOS terminal power outlet as
a dedicated point. The supply should have a reliable ground at the
switchboard.
Configuration Any number of methods can be used to install the iSPOS,
dependant on countertop configuration, user preference and peripherals
connected. It can simply sit on the countertop, in which case care must be
taken to ensure it cannot be knocked off the countertop when bumped. It
can also be fixed to the countertop using the provided base unit or
mounted on vesa bracket or arm. It would be impossible to cover every
installation situation in this manual so each should be considered
individually
.

3.2 Mounting

The iSPOS is designed to be fitted with a base unit or with a VESA
standard mounting bracket or arm (75 mm X 75 mm; 100 mm X 100 mm) if
required.
Unscrew the two screws securing the base unit to the LCD panel.
Separate the LCD Panel from the base unit by lifting the LCD panel.
21
iSPOS User's manual