ABB RET670 Product Manual page 87

ABB
Transformer protection RET670 ANSI
Pre-configured
Product version: 1.2
Test switch
The test system COMBITEST intended for use with
the IED 670 products is described in 1MRK 512
001-BEN and 1MRK 001024-CA. Please refer to
the website: www.abb.com/substationautomation
for detailed information.
Test switches type RTXP 24 is ordered separately.
Please refer to Section "Related documents"
reference to corresponding documents.
Protection cover
Protective cover for rear side of RHGS6, 6U, 1/4 x 19"
Protective cover for rear side of terminal, 6U, 1/2 x 19"
Protective cover for rear side of terminal, 6U, 3/4 x 19"
Protective cover for rear side of terminal, 6U, 1/1 x 19"
External resistor unit
High impedance resistor unit 1-ph with resistor and voltage
dependent resistor for 20-100V operating voltage
High impedance resistor unit 3-ph with resistor and voltage
dependent resistor for 20-100V operating voltage
High impedance resistor unit 1-ph with resistor and voltage
dependent resistor for 100-400V operating voltage
High impedance resistor unit 3-ph with resistor and voltage
dependent resistor for 100-400V operating voltage
Combiflex
Key switch for settings
Key switch for lock-out of settings via LCD-HMI
Note: To connect the key switch, leads with 10 A Combiflex socket on one end must be used.
Side-by-side mounting kit
RHGS 6 Case or RHGS 12 Case with mounted
RTXP 24 and the on/off switch for dc-supply are
ordered separately. Please refer to Section
"Related documents"
corresponding documents.
for
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
Quantity:
1MRK 504 118-BUS A
for reference to
1MRK 002 420-AE
1MRK 002 420-AC
1MRK 002 420-AB
1MRK 002 420-AA
1 2 3
RK795101-MA
RK795101-MB
1 2 3
RK795101-CB
RK795101-DC
1MRK 000 611-A
1MRK 002 420-Z
87