Circuit Breaker - Wen 6550 Owner's Manual

WARNING: This tool is for indoor use only. Do not expose to rain or use in damp locations.
GUIDELINES FOR USING EXTENSION CORDS
Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy
enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting
in loss of power and overheating. The table below shows the correct size to be used according to cord length and
nameplate ampere rating. When in doubt, use a heavier cord. The smaller the gauge number, the heavier the cord.
Make sure your extension cord is properly wired and in good condition. Always replace a damaged extension cord
or have it repaired by a qualified person before using it.
Protect your extension cords from sharp objects, excessive heat and damp/wet areas.
Use a separate electrical circuit for your tools. This circuit must not be less than a #12 wire and should be protected
with a 15 A time-delayed fuse. Before connecting the motor to the power line, make sure the switch is in the OFF
position and the electric current is rated the same as the current stamped on the motor nameplate. Running at a
lower voltage will damage the motor.
WARNING: This tool must be grounded while in use to protect the operator from electric shock.
AMPERAGE
15 A

CIRCUIT BREAKER

This planer is equipped with a motor protection
device-circuit breaker. The breaker will automati-
cally shut the planer off when excessive current
is consumed. If the breaker is tripped, turn the
planer off and reset the circuit by pressing the
button.
CAUTION: Be sure to turn the planer off prior
to resetting the circuit breaker to avoid uninten-
tional start-up of the planer.
6
ELECTRICAL INFORMATION
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft.
14 gauge
50 ft. 100 ft.
12 gauge 10 gauge
Switch
Circuit Breaker
150 ft.
8 gauge