ITU-T G.8032 Ethernet Ring Protection Switching
Command or Action
Step 4
end
Example:
Device(config)# end
Configuring a Service Instance
To configure a service instance, complete the following steps.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface type number
4. service instance instance-id ethernet [evc-id]
5. encapsulation dot1q vlan-id [native]
6. bridge-domain bridge-id [split-horizon [group group-id]]
7. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2
configure terminal
Example:
Device# configure terminal
Step 3
interface type number
Example:
Device(config)# interface gigabitethernet 0/1/0
Purpose
Returns to user EXEC mode.
LAN Switching Configuration Guide, Cisco IOS XE Everest 16.6.1 (Cisco NCS 4200 Series)
Configuring a Service Instance
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Specifies the interface type and number.
27