Connect MyGenius to the PC. The PC will start the driver installation procedure for
the MyGenius device. Please follow the steps in order to install properly the device.
Now the software and the tool will be updated to the latest available version.
After the update the unit can be used on the vehicle.
Connect the MyGenius to the cable supplied with the kit, then connect the cable to
the diagnostic port of the vehicle.
(The vehicle's diagnostic port is often located under the steering wheel but,
depending on the brand/model/type, it can be located in a different place)
Before any operation on the car check that the vehicle is properly serviced and no warning
lights are lit on the dashboard, if anything is wrong the vehicle MUST be first serviced and
repaired by a car dealer or repair shop.
The car battery MUST BE FULLY CHARGED and during all the MyGenius operations on the
vehicle we strongly suggest to connect a stabilized car battery charger.
During the reading/programming operations do not unplug the OBD II wire or perform
whatever operation with dashboard. To avoid any communication troubles do not switch on
AC, radio or any other devices that require car battery power.
Follow the instructions requested by the MyGenius
FIRST USE – UPDATE
Now you are ready to run the
software. At the start of the
software you will be asked for
a mandatory update.
IMPORTANT!
November 2017
USER MANUAL
Ver.2.06
Pag. 5/22
Need help?
Do you have a question about the F32 MYGENIUS and is the answer not in the manual?