Reset Procedure - DimSport F32 MYGENIUS User Manual

RESET procedure must be performed ONLY in 3 cases :
1. WRONG PROTOCOL SELECTION: during the manual reading procedures (check page 15) the
client selects the wrong protocol to read or identify the ECU.
2. STOCK FILE REFLASHED TO THE ECU: if the dealership (or anyone else), during a standard
service (or any other programming operation with different tools), overwrites the STOCK file stored
in the ECU with a newer software update (different ID) the MyGenius will not be able to write back
any mod file. (Before any service - or any other programming operation with different tools – we
strongly advice the client to always reflash the vehicle with its stock file).
3. TUNED FILE REFLASHED TO THE ECU: if the dealership (or anyone else), during a standard
service (or any other programming operation with different tools), overwrites the MODIFIED file
stored in the ECU with a new stock file and a new software update (different ID) the MyGenius will
not be able to write back any mod file.
(Before any service - or any other programming operation with different tools – we strongly advice
the client to always reflash the vehicle with its stock file)
1
. During the manual reading procedure MyGenius asks to select the correct protocol for the reading, IF
the customer selects the wrong protocol the reading will be unsuccessful and the MyGenius tool needs
to be reset through the RESET procedure.
After clicking OK, the MyGenius unit will be ready for a new reading procedure, please verify with your
Master which is the correct protocol to be used on this vehicle.

RESET PROCEDURE

IMPORTANT!
November 2017
USER MANUAL
Ver.2.06
Pag. 16/22