Digital-Ally FirstVu HD One Operation Manual page 10

FirstVu HD One™ Operation Guide
Settings: 0-60 seconds [default = 0 seconds]
Record Quality
The Record Quality parameter allows the video compression bit rate to be
adjusted. Digital video is compressed by taking out data that remains
constant from each frame, and only storing data that actually changes. This
allows videos with still backgrounds to be much smaller than they would be
if the background had to be present in every single frame.
The bit rate is the amount of bits that can be used in one second of video.
The higher the record quality, the higher the bit rate and the size of the
event files. The default setting is "high" for a good mix between video
qualities and upload time, but can be lowered or raised to adjust quality and
storage space.
Settings: Standard (2Mbps), Medium (4Mbps), High (6Mbps) [default], Super High (12Mbps)
Record Size
The Record Size parameter allows the video image size to be adjusted from
VGA (standard definition) to 720p (high definition). VGA has a picture size
of 640x480 pixels, whereas 720p has a picture size of 1280x720 pixels.
720p will provide a larger & more defined video picture, but because of its
larger size, will require about 3 times as much storage space as VGA. Also,
the shape of the final video frame will be slightly different, with 720p being a
wider frame (higher width ratio to height).
Settings: VGA (640x480), and 720p (1280x720) [default]
Audio Mode
The audio mode determines how audio will be recorded to your device. If
enabled, audio information is recorded during the recorded event and
during the configured pre-event time.
If enabled (w/o Pre-event), audio will be recorded during the event but not
recorded during pre-event. If this option is disabled, no audio will be
recorded.
Settings: Enabled, Disabled, Enabled (w/o Pre-Event) [default]
Frames Per Second
This parameter sets the number of frames per second the FirstVu HD One
will record. The higher the setting, the better the video quality, and the
larger the size of the event files.
Settings: 5, 10, 15, 30fps [default = 30fps]
Record LED (covert mode)
The Red Record LED behavior on the camera can be configured to
accommodate your desired operation. If disabled, the LED will not
illuminate during a recorded event and will operate in covert mode.
Settings: Off, On [default]
Digital Ally, Inc. | Device Configuration – VuVault
860-00260-00 Draft 02
7