Nac HotShot User Manual page 20

'Connect Selected Cameras' button or disregarded by clicking the 'Cancel'
button. Note the 'Position' field can not be changed.
6. After any changes have been made the camera can be connected by ticking the
camera's name and clicking the 'Connect Selected Cameras' button, this will
also save all the cameras in the list even if not checked to memory for future
use. Clicking the 'Cancel' button will not connect any camera and disregard
any changed made.
The camera setup options are, Master and Slave, Master cameras will generate its own
timings and export them. Slave cameras will require timings from another camera.
The 'Slave' mode is used to frame synchronizes two or more camera. Colour Setup
applies a Bayer RGB pattern if it's a colour camera or uses a single monochrome
channel if monochrome is chosen. Depending on the colour setup of the camera in
position 1 will determine which colour setup gets applied to all subsequent cameras.
7. The 'Camera / video list controls' box will now look like this. The status
column in the grid will show what tasks the camera is performing while the
software attempts to connect it. If more than one camera was checked in the
camera inventory window the software will attempt connection which each
camera in the position order starting with the camera connected to the PCI
board closest to the CPU on the motherboard, Position 1.
There are two other buttons above the grid:
1. The Folder icon on the button on the top left can open up AVI's, streams of
BMPs, TIFs and JPEGs, and BIN's (Raw Binary data from the PCI control
board's buffers for review.
2. The 'Default Settings' button opens up the 'Preferences' window, see below.
20