Table of Contents
Advertisement
Erasing the entire HomeLink
Before programming
■
Install a new battery in the remote control transmitter.
●
The battery side of the remote control transmitter must be pointed away from
●
the HomeLink
Certification for the garage door opener
■
For vehicles sold in the U.S.A.
FCC ID: CB2070AHL4
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
For vehicles sold in Canada
NOTE:
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interfer-
ence that may cause undesired operation of the device.
When support is necessary
■
Visit on the web at www.homelink.com or call 1-800-355-3515.
memory (all three programs)
button.
3-7. Other interior features
Press and hold the 2 outside but-
tons for 10 seconds until the indi-
cator light flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
HomeLink
memory.
3
381
Advertisement
Table of Contents
