Table of Contents
Advertisement
PPP Authentication: Select PPP authentication mode from this drop-down box,
available options: NONE, PAP, CHAP and Either.
PAP: Password Authentication Protocol;
CHAP: Challenge Handshake Authentication Protocol;
None: It means that there is no protocol will be used.
Either: It means that the Device will automatically negotiate it with the peer
device.
LAN IP Address: Enter the IP address for the Device's LAN interface.
LAN Subnet Mask: Enter the subnet mask for the Device's LAN interface.
Primary DNS Server: Enter the IP address of your ISP's primary DNS server.
Secondary DNS Server: Enter the IP address of your ISP's secondary DNS server
if it is available.
Advanced Options: Select this check box to configure advanced parameters. In
most case, you need not configure them.
Service Name: Enter the Service Name, if provided by your ISP.
MRU: The MRU (Maximum Receive Unit) setting specifies the largest packet size
permitted for network receive. In most cases, keep the default value (1492). When
dialing, the Device will automatically negotiate it with the peer device.
Dial Type: Select type of dial connection from this drop-down box, available options:
Always On, Manual and On Demand.
Always On: If you want the Device to establish a PPPoE session when starting
up and to automatically re-establish the PPPoE session once disconnected,
select this option.
Manual: If you want to dial and hang up a PPPoE session manually, select this
option. In the case of Manual type, you should dial and hang up manually in the
Internet Connection List on Basic Setup > Internet Connection page (See
chapter 3.3.3).
On Demand: If you want the Device to establish a PPPoE session only when
there are packets requesting to access the Internet (i.e., when a program on
your computer attempts to access the Internet), select this option.
Page 20
Advertisement
Table of Contents
